GATE2018-36

gatecse asked in Bioprocess Engineering and Process Biotechnology Feb 20, 2018 edited Dec 19, 2020 by go_editor

0 votes

Shear stress versus shear rate behavior of four different types of fluids (I, II, III and IV) are shown in the figure below.

Which one of the following options is correct?

I-Newtonian, II-Bingham plastic, III-Dilatant, IV-Pseudoplastic
I-Pseudoplastic, II-Dilatant, III-Newtonian, IV-Bingham plastic
I-Newtonian, II-Pseudoplastic, III-Bingham plastic, IV-Dilatant
I-Newtonian, II-Bingham plastic, III-Pseudoplastic, IV-Dilatant

gate2018
bioprocess
engineering

gatecse asked in Bioprocess Engineering and Process Biotechnology Feb 20, 2018 edited Dec 19, 2020 by go_editor

by gatecse

1.4k points

0 Comments

Please log in or register to add a comment.

Please log in or register to answer this question.

0 Answers

Answer:

Related questions

0 votes

0 answers

gatecse asked in Bioprocess Engineering and Process Biotechnology Feb 20, 2018

GATE2018-13
Which one of the following bioreactor configurations is the basis for a trickling biological filter? Stirred tank Packed bed Air lift Fluidized bed

gatecse asked in Bioprocess Engineering and Process Biotechnology Feb 20, 2018

by gatecse

1.4k points

gate2018
bioprocess
engineering

0 votes

1 answer

gatecse asked in Bioprocess Engineering and Process Biotechnology Feb 20, 2018

GATE2018-50
At the end of a batch culture, glucose solution is added at a flow rate of $200 \: ml/h$. If the culture volume after $2$ h of glucose addition is $1000$ ml, the initial culture volume (in ml) is _________

gatecse asked in Bioprocess Engineering and Process Biotechnology Feb 20, 2018

by gatecse

1.4k points

gate2018
bioprocess
numerical-answers

0 votes

0 answers

gatecse asked in Bioprocess Engineering and Process Biotechnology Feb 20, 2018

GATE2018-46
A microbial strain is cultured in a $100$ L stirred fermenter for secondary metabolite production. If the specific rate of oxygen uptake is $0.4 \: h^{-1}$ and the oxygen solubility in the broth is $8 $ ... $s^{-1}$) of oxygen required to achieve a maximum cell concentration of $12$ g/L is (up to two decimal places) ___________

gatecse asked in Bioprocess Engineering and Process Biotechnology Feb 20, 2018

by gatecse

1.4k points

gate2018
bioprocess
fermenter
numerical-answers

0 votes

0 answers

gatecse asked in Bioprocess Engineering and Process Biotechnology Feb 20, 2018

GATE2018-45
An aqueous solution containing $6.8$ mg/L of an antibiotic is extracted with amyl acetate. If the partition coefficient of the antibiotic is $170$ and the ratio of water to solvent is $85$, then the extraction factor is ________

gatecse asked in Bioprocess Engineering and Process Biotechnology Feb 20, 2018

by gatecse

1.4k points

gate2018
bioprocess
technology
numerical-answers

0 votes

0 answers

gatecse asked in Bioprocess Engineering and Process Biotechnology Feb 20, 2018

GATE2018-44
Moist heat sterilization of spores at $121 ^\circ C$ follows first order kinetics as per the expression: $\dfrac{dN}{dt}=-k_dN$ where, $N$ is the number of viable spores, $t$I is the time, $k_d$ is the rate constant and $\dfrac{dN}{dt}$ is the rate of ... the number of viable spores from an initial value of $10^{10}$ to a final value of $1$ is (up to two decimal places) __________

gatecse asked in Bioprocess Engineering and Process Biotechnology Feb 20, 2018

by gatecse

1.4k points

gate2018
bioprocess
technology
numerical-answers

Welcome to GATE BioTechnology, where you can ask questions and receive answers from other members of the community.

Send feedback

Developed by Chun